Tusk Offset Bar Risers

Rise and reach in one, brings the bars up and back for standing comfort.

• The Tusk 1-1/4” Offset Bar Risers offer flexibility for your handlebar setup. For most applications, the risers can be installed forward for approximately a 1-1/4" straight-up rise, or reversed for approximately a 1" rise that also brings the handlebars 1" closer to the rider.
• With a slotted hole design, the Tusk Offset Bar Risers easily bolt onto OEM clamps with a bolt spacing range of 31mm–42mm, fitting almost any bolt center-to-center distance. Compatible with both 7/8" (22mm) and 1-1/8" (28mm) handlebars, these risers are a great fit for motorcycles, dirt bikes, adventure bikes, ATVs, and more.
• Rise measurements are approximate and can vary depending on the angle of the motorcycle’s top triple clamp or bar mounts.
• Billet aluminum offset handlebar risers
• Install forward for approximately a 1-1/4" rise or reverse for approximately a 1" rise and 1" closer handlebar position (for most setups)
• Slotted hole design fits OEM clamps with 31mm–42mm bolt spacing
• Compatible with both 7/8" (22mm) and 1-1/8" (28mm) handlebars Flat Shim Instructions
• Flat shims are included but may not always be necessary.
• If the Tusk Offset Bar Risers do not sit flush on the OEM clamps, install the shims under the Bar Riser body for proper fitment.
• Do not place shims between the Bar Riser cap and the Bar Riser body.
• Weight: 0.8 lb
• Packaged size: 8 × 7.25 × 1.5 in